Attached is a photo of my new lift-a-dot plates. My snaps are shot and need replaced. I am guessing that these plates install as shown on the right, with those four little tabs going against the top. I don
Lift-A-Dot question. : MGB & GT Forum : The MG Experience
I am going to have to pull the "lift the dot" fasteners off of my car to fix some rust issues around them and again for proper paint work. This got me thinking: Is there any reason not to replace the stud and nut combo with a threaded insert or "nutsert"? Anybody know what the t
Lift The Dot replacement, thread pitch, and nutsert question
Hi Al! I need to replace a few lift-a-dot studs on my 70 MGB. Is there an easy way to get to the underside of the studs to attach the nut? Many Thanks
tonneau cover stud replacment : MGB & GT Forum : The MG Experience
Planning on getting a car lift for my shop and would prefer a two post lift. If the body isn
Car Lift : MGB & GT Forum : The MG Experience
lifting : MGB & GT Forum : The MG Experience
OK part two. A little housekeeping first. Please remember that we are talking about an MGB with stock type suspension (lever shocks, king pins etc.). In the first article, I didn’t describe what bump steer was (as pointed out). Instead I merely talked about when it occurs. Let me say right n
Lowering the suspension.part 2. NEW DIAGRAMS : MGB & GT Forum
lower trunnion : MGB & GT Forum : The MG Experience
Engine lifting points question : MGB & GT Forum : The MG Experience
MGB - Question on MGB door innerds
Lift-the-DOT® Fasteners, Screw Fixing Stud Type
Suspension – MGB tips mods and maintenance
MGB Door and Hinge Alignment : How-To Library : The MG Experience